Tavve zoneranger User Manual page 278

system property property_name property_value
no system property property_name property_value
tacacs
To configure the TACACS+ access control settings on the ZoneRanger. To remove a TACACS+
access control setting, use the no form of this command
tacacs [access-control|client-timeout|log-level|max-size|proxy-rule|server-timeout]
no tacacs [access-control|client-timeout|log-level|max-size|proxy-rule|server-timeout]
Syntax Description
access-control
client-timeout
log-level
max-size
proxy-rule
server-timeout
Usage Guidelines
Each of the TACACS+ commands will take effect immediately when executed. The proxy-
rule clauses are positional significant. Thus each proxy-rule clause takes an optional index
position which determines its place relative to the other rules. The indices start at 1. If no in-
dex position is specified, the rule is placed at the bottom of the list.
tacacs access-control admin-level admin_level
tacacs access-control command cmd
ZoneRanger 5.5 User's Guide
disabled Port is disabled
eth0 Port only available on ZoneRanger eth0 interface
eth1 Port only available on ZoneRanger eth1 interface
enabled Port is enabled
ranger-gateway Port is only available from the Ranger Gateway
property Configure ZoneRanger properties
property_name Property name to change/set
property_value Property value to name/set
Configure the TACACS+ access-control for the ZoneRanger itself
Timeout for TACACS+ client session
Level of logging on the ZoneRanger for TACACS+
Maximum size of a TACACS+ message
Specify which server group is selected for an incoming TACACS+ re-
quest from a managed device.
Timeout for TACACS+ server sessions
.
278