Tavve zoneranger User Manual page 302

createSecurityKey
Gateway commands or directories to control the access to Ranger Gateway commands. There are
three levels of security; security-admin, admin and operator, which may be specified.
destination directory is not specified, the security key is written to the install_dir/gateway/security
directory.
debugFilter
debugFilter [ zoneranger ] [-list | -add name level(1-15) | -remove name
| -clear ]
zoneranger
displays the list of currently configured debugging filters.
-list
specifies the service name and debug level for that service to add.
-add
-remove
-clear
debugFilter
a particular service or services on the ZoneRanger and Ranger Gateway. Debugging filters can
negatively effect the performance of the specified service so debugging filters should be cleared
after they are no longer needed by Tavve Support personnel. If a zoneranger is not specified, the
debugging filter will be applied to the Ranger Gateway.
debugLevel
debugFilter [[ zoneranger ] [ -set level(1-15)]] | -jni [ -set level(1-
15) ]
zoneranger
sets the overall debug level (default is 4).
-set
sets the debug level for the jni on the Ranger Gateway (default is 0).
-jni
debugLevel
the entire ZoneRanger or Ranger Gateway. This should only be used under the direction of Tavve
Support personnel. The use of non-default debugging levels will cause performance degradation for
the system. When
Ranger Gateway. When
current debug level of the specified ZoneRanger.
debugString
debugString [ -t timeout ] [ -x ] [ -v ] -list | -s service | -all
sets the timeout in seconds for the command to complete.
-t
outputs information in XML format. Not valid with -list
-x
outputs verbose information
-v
outputs the available service names
-list
outputs information about the specified service
-s
outputs information about all available services
-all
debugString
services on the Ranger Gateway. This should only be used under the direction of Tavve Support
personnel.
ZoneRanger 5.5 User's Guide
allows for the creation of security keys which may be applied to Ranger
specifies the name of the ZoneRanger
specifies the service name to remove from debugging.
removes all debugging filters.
is used, as directed by Tavve Support personnel, to record debugging information for
specifies the name of the ZoneRanger
is used, as directed by Tavve support personnel, to set the overall debugging level for
is used with no parameters, it displays the current debug level of the
debugLevel
debugLevel
is used, as directed by Tavve support personnel, to display information about
is used with only the zoneranger parameter, it displays the
If a
302