Tavve zoneranger User Manual page 226

Figure 35-17. Gateway Settings .. RGVI Window
The RGVI Enabled checkbox can be used to configure whether or not the RGVI service is enabled.
When the gateway settings are saved (i.e. by clicking the OK button in the Gateway Settings
dialog), if the RGVI Enabled checkbox was enabled, the Ranger Gateway will create a virtual
point-to-point interface on the Ranger Gateway server, and will begin listening for connection
requests from RGVI clients installed on management application servers.
RGVI clients communicate with the Ranger Gateway via UDP on a configured port (default: 1194).
The RGVI Port text box can be used to specify a different UDP port. Note that if a value other than
the default is used, all RGVI clients that are configured to connect to this Ranger Gateway will need
to have their configurations modified to use the new port. RGVI client configuration is described in
Appendix J.
The RGVI Clients list is used to configure the set of RGVI clients that are allowed to connect to
this Ranger Gateway. The RGVI service on the Ranger Gateway will only accept client connections
from addresses that are configured in this list.
The Add button displays a new Add RGVI Client dialog window which is used to configure a new
entry in the RGVI Clients list. Each entry consists of two parts:
1. An IP address, address pattern, or device group, used to identify the client or clients for
which this entry will be applied.
2. A list of subnet and/or host addresses to be intercepted by the corresponding RGVI
client(s), or an indication that the list of addresses should be identical to that configured for
the GVI service.
An initial set of subnet/host addresses to be intercepted can be configured in the Add RGVI Client
window. Once the RGVI client entry has been created, you can select an entry in the RGVI Clients
list and use the Use GVI Routes check box and Subnet/Host table to modify the intercept settings
associated with the selected client. To add a Subnet/Host to be intercepted, click the empty field at
the bottom of the Subnet/Host table, and enter the subnet or host address to be intercepted. To
modify a host or subnet address, select the corresponding entry in the table and edits its value. To
delete a host or subnet address, select the corresponding entry and click the Delete button.
ZoneRanger 5.5 User's Guide 226