Tavve zoneranger User Manual page 160

Setting
Pattern
Polling Interval
ICMP Timeout
ICMP Retries
Settings groups provide a convenient way to associate interface polling settings with individual
interfaces, or common interface polling settings with groups of interfaces (for example, all
interfaces on a specified node, or all interfaces with IP addresses matching a specified wild card
pattern).
The interface polling settings for a given interface are identified by searching through the set of
settings groups in order (from top to bottom as they are displayed in the table) until the first
match is found. Therefore, the order in which the settings groups are shown in the table is very
important. The arrows may be used to change the order of the settings groups.
The Polling Interval applies to both ICMP and SNMP polling. SNMP timeouts and retries may
be configured on the Configuration > SNMP page Managers tab.
Configuring TCP Polling Settings
ZoneRanger 5.5 User's Guide
Description
An IP address pattern, Node Group, the
IP address of an interface, or the fully
qualified hostname of a node. The
address pattern, address, Node Group, or
hostname identifies the interface, set
of interfaces, or node to which settings
in the group are applied.
Time interval, in seconds, between
polling cycles
Length of time that the poller waits for
an ICMP response
Number of times that polling is
attempted before an ICMP failure is
reported
160