Tavve zoneranger User Manual page 176

System
After ZoneRanger is installed, configured, and running, Configuration > System page can be
used to modify the ZoneRanger system configuration.
Figure 34-62. Configuration > System page IP tab
Modifying the network settings
ZoneRanger has two Ethernet interfaces which may be configured using the Configuration >
System page IP tab.
By default, the Ethernet interfaces on the ZoneRanger are configured to automatically set the
interface speed. However, if necessary, the interface speed and duplex type may be specified on
the IP tab.
If the ZoneRanger is connected to a 802.1q VLAN trunk, the Connect to VLAN trunk check
box should be selected. Primary VLAN ID defines the VLAN id the ZoneRanger should use
for its communications. Use blank or (zero) as the Primary VLAN ID to denote native
0
mode. Use the Add VLAN button to add each VLAN that the ZoneRanger will participate in.
Note: Saving any changes on this tab results in a ZoneRanger restart.
ZoneRanger 5.5 User's Guide 176