Tavve zoneranger User Manual page 290

whitelist
To change the whitelist configuration on the ZoneRanger. To disable whitelisting, use the no form
of this command
whitelist
no whitelist
Usage Guidelines
Whitelist changes are made within the whitelist configuration submode. Once you are in the
whitelist configuration submode, the following configuration commands are available:
add ip_address_pattern
delete ip_address_pattern
Example
This example shows how to add whitelist entry.
ZoneRanger 5.5 User's Guide
.
•
add – Add an IP address pattern
•
cancel - Exit whitelist without saving any changes
•
clear – Clear all whitelist entries
•
delete – Delete an IP address pattern
•
enforce-outbound-requests – Blocks all traffic with addresses outside of the
whitelist
•
exit – exit server group mode (saving changes)
•
list – Lists the IP Address patterns
•
no – Disable settings
•
test – Apply the IP address patterns for 60 seconds
add
ip_address_pattern
delete
ip_address_pattern
zr# whitelist
zr(whitelist settings)# add 10.1.10.*
zr(trap-filter)# exit
Adds a IP address pattern to the whitelist.
IP address pattern to add
Removesan IP address pattern from the whitelist.
IP address pattern to delete
290