Tavve zoneranger User Manual page 227

To modify the address, address pattern, or device group used to identify an RGVI Clients table
entry, right-click on the entry in the RGVI Clients list, and click Modify. This will open the
Modify RGVI Client dialog window, which also can be used to modify any settings associated
with the entry. To remove an RGVI Clients table entry, right-click on the entry and click Delete.
The Up and Down buttons, located below the RGVI Clients list, are used to change the order of the
entries in the RGVI Clients list. When an RGVI client attempts to connect to the Ranger Gateway,
the set of host and subnet addresses to be pushed to the client will be based on the first matching
entry in the RGVI Clients list. If specific host addresses are always used to identify RGVI clients,
there will only be one matching entry for any given client, so the order of the entries does not
matter. However, if address patterns or device groups are used to identify RGVI clients, it is
possible that multiple entries may match a given client, so the order of the entries in the RGVI
Clients list becomes important.
Important Note: The set or host/subnet addresses to be intercepted by an RGVI client is pushed to
the RGVI client at the point where the client connects with the Ranger Gateway, and cannot be
modified after the connection is established. As a result, whenever the set of host/subnet addresses
to be intercepted by a client is modified on the Ranger Gateway, it will be necessary to restart any
affected clients.
Gateway Settings...SNMP Proxy
The Gateway Settings...SNMP Proxy window provides the mechanism to configure the SNMP
Proxy settings on the Ranger Gateway.
Figure 35-18. Gateway Settings .. SNMP Proxy Window
If the IP Address Aliasing or Community String Conventions mechanisms for SNMP proxy are
being used (see Chapter 26), the Ranger Gateway will need to be configured to listen for SNMP
proxy requests on a configured port. In order to configure this port, and any associated settings, the
Community String SNMP Proxy Enabled checkbox must be checked. The following settings can
be configured when this checkbox is enabled:
ZoneRanger 5.5 User's Guide 227