Tavve zoneranger User Manual page 180

ZoneRanger Port
HTTP
HTTPS
ICMP
Messaging Port
NTP
RADIUS Proxy
SNMP Agent
SNMP Trap Port
SSH
Syslog Port
TACACS+ Proxy
Telnet
TFTP Server
Note: When Virtual IP is enabled, it will open a UDP port on the configured interface. This port
is used for communication between redundant ZoneRangers. This UDP Port is configured on
the Configuration > Peers page Virtual IP tab.
Note: If the ZoneRanger web interface is unavailable, you can run the
from a joined Ranger Gateway to enable and disable the listed ports, except for the messaging
port.
Configuring ZoneRanger properties
Properties are used to configure or display some aspect of ZoneRanger operation.
Configuration > System page Properties tab list the current set of ZoneRanger properties. In
general, properties are used for advanced tuning and analysis.
ZoneRanger 5.5 User's Guide
Description
HTTP ports (80 and 8080) for the
ZoneRanger web server. The Ranger Gateway
Only option disables direct access to the
web server, but permits proxy access
through a joined Ranger Gateway.
HTTPS ports (443 and 8443) for the secure
ZoneRanger web server. The Ranger Gateway
Only option disables direct access to the
secure web server, but permits proxy
access through a joined Ranger Gateway.
Enables and disables ICMP from the
specified interface.
Only option disables direct access via
ICMP, but permits proxy access through a
joined Ranger Gateway.
Port to use for communication between
ZoneRanger and Ranger Gateway.
changed, the messaging ports of all joined
Ranger Gateways and redundant ZoneRangers
must be updated
NTP server port (123)
RADIUS ports (1812 and 1813) used to proxy
RADIUS requests
SNMP agent port (161).
SNMP trap port (162) used to receive
external SNMP traps.
SSH port (22) used to connect to the
ZoneRanger configuration. The Ranger
Gateway Only disables direct access to
SSH, but permits proxy access through a
joined Ranger Gateway
Syslog port (514) used to receive Syslog
messages.
TACACS+ port (49) used to proxy TACACS+
requests.
Telnet port (23) used to connect to
ZoneRanger configuration.
TFTP server port (69).
The Ranger Gateway
If
portControl
command
The
180