Tavve zoneranger User Manual page 309

•
list-routes
•
clear-routes
•
config [ item [ value ]]
•
test [ address ]
gvi enable
By default, the GVI service is disabled.
When the
interface, add any required ZoneRanger host routes and any configured virtual interface routes
to the system routing table, and will begin handling any management traffic that is received on
the virtual interface.
Note: On Windows systems, the
enabled after Ranger Gateway installation. Also, once the GVI is enabled, run the Windows
command ncpa.cpl to display the current list of network interfaces. Using the Advanced >
Advanced Settings... menu item, verify that the GVI virtual interface is last in the access order
for network services.
gvi disable
gvi disable
executed, the Ranger Gateway will stop handling management traffic received on the virtual
interface, will delete the virtual interface routes and ZoneRanger host routes, and will remove
the virtual interface.
gvi status
gvi status
subcommand indicates whether the GVI service is currently enabled or disabled and displays
any errors or warnings that were generated during the most recent route manager operation.
gvi generate-routes –subnet|-address -database|-proxyMap
-
subnet
-
address
-database
potential additions as GVI routes
-proxyMap
potential additions as GVI routes
gvi generate-routes
information, or ZoneRanger database information, to identify subnets or individual IP addresses
that may be considered as candidates for the GVI route list.
The intent of the
the subnets or IP addresses for which virtual interface routes may need to be created. The
options for the
information that will be listed (i.e. subnets or individual IP addresses), and the source of the
information (i.e. the databases of all joined ZoneRangers, of the Ranger Gateway's proxy map
configuration).
ZoneRanger 5.5 User's Guide
[-all]
[-f]
subcommand is executed, the Ranger Gateway will create the virtual
gvi enable
tuntap
subcommand disables the GVI service. When the
subcommand displays the current status of the GVI service. The gvi status
indicates to list subnets as potential additions as GVI routes
indicates to list individual IP addresses as potential additions as GVI routes
indicates to use the databases of all joined ZoneRangers as the source of
indicates to use the Ranger Gateway Proxy Map service as the source of
subcommand incorporates other Ranger Gateway configuration
gvi generate-routes
gvi generate-routes
subcommand enables the GVI service.
gvi enable
command must be executed before the GVI service is
gvi disable
subcommand is to facilitate the process of identifying
subcommand are used to specify the type of
subcommand is
309