Tavve zoneranger User Manual page 223

Figure 35-14. Gateway Settings .. Proxy Map Window Routes tab
The Proxy Map windows Route tab allows for the creation of proxy routing rules that map the
destination IP address of the incoming request to the Ranger Gateway (i.e. the RG Address), to a
ZoneRanger that can proxy the request to the target device (i.e. the ZoneRanger), and, in cases
where address translation is required, the IP address that the ZoneRanger should use to send traffic
to the target device (i.e. the ZR Address).
To add a new route, click the entry fields at the bottom of the list and fill in the appropriate
information. The RG Address field may be a Device Group or an IP address pattern. The ZR
Address field may be an IP address pattern. To delete a route, select the route and click the Delete
button.
The Weight field indicates the relative cost of each proxy map route. If there are more than one
proxy map routes which match an incoming request, the lowest cost proxy map entry will be chosen
if that ZoneRanger is responsive. The default weight, if not specified, is zero, which is the least
cost.
To reorder the set of routes, select a route and use the Up and Down buttons to move the particular
rules. The Organize button will order the rules with more specific routes to less specific routes.
Gateway Settings...Proxy Ports
The Gateway Settings...Proxy Ports window provides the mechanism to configure the Proxy
Access Control service on the Ranger Gateway. The Proxy Access Control Service is described in
detail in Chapter 12.
ZoneRanger 5.5 User's Guide 223