Tavve zoneranger User Manual page 249

forward log-level [ none | short | full ]
no forward log-level [ none | short | full ]
forward netflow local_port [ ranger_gateway destination_host | dest-group group-name |
data-diode ] destination_host_port [ source_addresses | enable | disable ]
no forward netflow local_port [ ranger_gateway destination_host | dest-group group-name |
data-diode ] destination_host_port [ source_addresses | enable | disable ]
ZoneRanger 5.5 User's Guide
Once you are have entered a destination group name, the destination group submode al-
lows you to enter destination group entries. Once you are in the destination group sub-
mode, the following configuration commands are available:
•
cancel - Exit this mode without saving any changes
•
clear-group-entries – Clear all destination group entries
•
exit – exit destination group mode (saving changes)
•
group-entry – Destination group entry
•
list – List the current set of destination group entriest.
•
no – remove or use default settings
group-entry [ gateway_name hosts | dest-group group_name | data-diode ]
no group-entry [ gateway_name hosts | dest-group group_name | data-diode ]
group-entry
gateway_name
hosts
dest-group
group_name
data-diode
no
log-level Configure logging level for forwarding
none No logging (default)
short Message header or length is logged
full Entire message is logged
no Delete forwarding log level
local_port
ranger_gateway
destination_host
dest-group
Adds a destination group rule to the group.
Hostname or IP address of a joined Ranger Gateway.
Comma separated list of destination IP addresses or host-
names
Adds an already defined destination group as a rule
Destination group name to add as a rule
Adds Data Diode as the destination rule
Removes a destination group entry
ZoneRanger port to receive NetFlow packets.
Hostname or IP address of a joined Ranger Gateway.
Hostname or IP address to which ZoneRanger should
forward NetFlow packets
Forward to destination group
249