Tavve zoneranger User Manual page 217

Figure 35-8. Gateway Settings .. GVI Window
The GVI Enabled checkbox can be used to configure whether or not the GVI service is enabled.
When the gateway settings are saved (i.e. by clicking the OK button in the Gateway Settings
dialog), if the GVI Enabled checkbox was enabled, the Ranger Gateway will create a virtual point-
to-point interface on the management application server, and will receive all traffic that is routed to
this virtual interface.
The GVI Routes list specifies the set of addresses that should be routed to the virtual interface. An
address may be specified as a entire subnet (e.g. 10.0.0.0/255.255.255.0) or a specific address (e.g.
10.2.5.6). To add a new address, select the empty entry at the end of list and enter the address
Delete
information. To delete entries, select the appropriate entries and click the button.
Gateway Settings...ICMP Proxy
The Gateway Settings...ICMP Proxy window provides the configuration information for the
Ranger Gateway ICMP Proxy service.
ZoneRanger 5.5 User's Guide 217