Installing The Bus Terminating Module - Siemens Simatic ET 200S Operating Instructions Manual

Assembling

4.8 Installing the bus terminating module

4.8 Installing the bus terminating module
4.8
Introduction
The terminating module on the right end of the ET 200S terminates the ET 200S distributed
I/O system. If you have not inserted a terminating module, the ET 200S is not ready for
operation.
Requirements
The last terminal module must be installed.
Installing the bus terminating module
1. Hook the bus terminating module onto the rail to the right of the last terminal module.
2. Pivot the terminating module backwards onto the DIN rail.
3. Push the bus terminating module to the left until you hear it lock into the last terminal
Figure 4-12
4-18
module.
Installing the bus terminating module
1
3
2
Operating Instructions, 12/2005, A5E00515771-03
ET 200S