Installing Additional Terminals - Siemens Simatic ET 200S Operating Instructions Manual

Assembling

4.5 Installing additional terminals

4.5 Installing additional terminals
4.5
Introduction
• The additional terminals expand the function of the terminal modules for ET 200S.
• The terminal modules and additional terminals can be prewired (without COMPACT
• Various voltage groups can be created on the additional terminals by means of pluggable
Requirements
• The DIN rail is installed.
• The terminal module for COMPACT modules is mounted or the terminal modules TM-P
Required tools
4-mm screwdriver
4-10
The additional terminals can be used to load addition potentials (e.g. for the connection of
sensors and actuators in 3 and 4 conductor technology for IM151-1 COMPACT).
The additional terminals can be cascaded if additional potentials are required.
modules or I/O modules).
bridges.
and TM-E are mounted to a width of 120 mm.
Note
Requirements for installing the additional terminals under terminal modules TM-P and
TM-E
Both "outer" terminal modules must be the same height. No terminal modules of a greater
height may be plugged between these two terminal modules.
Operating Instructions, 12/2005, A5E00515771-03
ET 200S