Siemens Simatic ET 200S Operating Instructions Manual page 64

Assembling
4.3 Installing the TM-P and TM-E terminal modules
Installing the terminal module
1. Fit the terminal module onto the rail.
2. Push in the terminal module at the bottom until you can hear the catch lock.
3. Move the terminal module to the left until you hear it snap into place at the previous
Figure 4-3
Removing the terminal module
The terminal module is wired, and there are other terminal modules on the right and left.
A terminal module in the ET 200S distributed I/O system can only be removed when there is
a clearance of approx. 8 mm to the adjacent terminal modules (you achieve this clearance
by moving the adjacent modules).
1. Switch off the supply voltage on the terminal module and, if applicable, the power
2. Disconnect the wiring on the terminal module.
4-6
interface module (if already installed) or the terminal module.
Installing the terminal module
module.
1
3
2
Operating Instructions, 12/2005, A5E00515771-03
ET 200S