Siemens Simatic ET 200S Operating Instructions Manual page 220

General technical specifications
9.4 Mechanical and Climatic Ambient Conditions
This area of application of 0 to 50 °C (vertically-mounted) is permitted for the following
modules only:
• 2AI U ST: 6ES7134-4FB01-0AB0
• 2AI I 2WIRE ST: 6ES7134-4GB01-0AB0
• 2AI I 4WIRE ST: 6ES7134-4GB11-0AB0
• 2AI I 2/4WIRE HF: 6ES7134-4MB00-0AB0
• 2AI RTD ST: 6ES7134-4JB50-0AB0
• 2AI TC ST: 6ES7134-4JB00-0AB0
• 2AO U ST: 6ES7135-4FB01-0AB0
• 2AO I ST: 6ES7135-4GB01-0AB0
Mechanical ambient conditions
The mechanical ambient conditions are shown in the following table in the form of sinusoidal
vibrations.
ET 200S modules
All modules except motor starters
Testing mechanical ambient conditions
The following table provides information on the type and extent of tests for mechanical
ambient conditions.
Test for ... Test standard
Vibrations Vibration test in
accordance with
IEC 60068-2-6
Shock Shock, tested in
accordance with
IEC 60068-2-27
9-8
Note
None of the supply and load voltages of the ET 200S are permitted to exceed 24 VDC.
This voltage limit must be ensured.
Frequency range
10 ≤ f ≤ 58 Hz
58 ≤ f ≤ 150 Hz
Constant
0.15 mm amplitude
2 g constant acceleration
Terminal modules and electronic modules
Type of vibration: Frequency sweeps with a rate of change of 1
octave/minute.
10 Hz ≤ f ≤ 58 Hz, constant amplitude of 0.35 mm
58 Hz ≤ f ≤ 150 Hz, constant acceleration of 5 g
Duration of vibration: 20 frequency sweeps per axis in each of the
3 mutually vertical axes
Type of shock: Half-sine
Strength of shock: 15 g peak value, 11 ms duration
Direction of shock: 3 shocks each in +/- direction in each of the
3 mutually vertical axes
Intermittent
0.35 mm amplitude
5 g constant acceleration
Operating Instructions, 12/2005, A5E00515771-03
ET 200S