Parameters For The Im151-3 Interface Module - Siemens Simatic ET 200S Operating Instructions Manual

See also
Assigning parameters for option handling (Page 7-11)
10.2.4

Parameters for the IM151-3 interface module

Table 10-5
Bus length
Interference frequency
suppression
Reference junction slot
Reference junction input
10.3 Parameter description for the interface modules
10.3
10.3.1 DP interrupt mode
Note
This parameter only used for IM151-1 STANDARD (6ES7151-1AA04-0AB0 or higher),
and IM151-1 HIGH FEATURE.
This parameter allows you to enable or disable DPV1 operation of the ET 200S. If DPV1
operation is enabled, data records and interrupts are supported (can be assigned
parameters) by means of Class 1 and Class 2services.
Requirements:
• The DP master must also supports DPV1.
10.3.2 Bus length
≤ 1 m: Default setting - the maximum bus length is 1 m.
> 1 m: The bus length of the ET 200S is > 1 m up to a maximum of 2 m. This setting will,
however, increase the response time of the ET 200S.
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
Parameters for the IM151-3 interface module
IM151-3
≤ 1 m / > 1 m
50 Hz/60 Hz
None /2 to 63
RTD on channel 0/
RTD on channel 1
10.3 Parameter description for the interface modules
Value range Default setting
≤1 m
50 Hz
None
0
Interface modules
Applicability
ET 200S
ET 200S
ET 200S
ET 200S
10-5