Siemens Simatic ET 200S Operating Instructions Manual page 121

Requirements for commissioning
The following additional requirements must be satisfied for commissioning the ET 200S on
PROFIBUS DP:
• DP slave installed
• DP slave wired up
• DP slave is configured (configured and parameters assigned)
• Supply voltage for the DP master is switched on (see manual for the DP master)
• DP master is switched to RUN mode (see manual for the DP master)
Procedure
To commission the DP slave, proceed as follows:
1. Switch on the power supply for the DP slave.
2. If necessary, switch on the supply voltage for the load.
See also
Basic principles of configuration for the ET 200S on PROFIBUS DP (Page 6-1)
Basic principles of installation (Page 4-1)
Setting the PROFIBUS Address (Page 6-9)
Wiring rules for the ET 200S (Page 5-7)
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
6.2 Commissioning on PROFIBUS DP
Commissioning
6-11