Table 2-1 Configuration Table In Hw Config For Profinet Io; Configuring Et 200S In The Simatic Manager - Siemens Simatic ET 200S Operating Instructions Manual

2.1.4

Configuring ET 200S in the SIMATIC manager

Procedure
1. Start SIMATIC Manager, and create a new project with a DP master (e. g., CPU315-2
2. Create the PROFIBUS subnet.
3. Connect the PROFIBUS subnet with the DP master in HW Config.
4. Take the ET 200S from the hardware catalog and put it on the PROFIBUS.
5. Set the PROFIBUS address 3 for the ET200S.
6. Drag the individual ET 200S modules from the hardware catalog to the configuration
7. Mark the electronic modules in the configuration table, and click the "Pack addresses"
Table 2-1 Configuration table in HW Config for PROFINET IO
Module/
DP identification
1 6ES7138-4CA01-0AA0 PM-E 24 VDC
2 6ES7131-4BB01-0AB0 2DI 24 VDC
3 6ES7131-4BB01-0AB0 2DI 24 VDC
4 6ES7131-4BB01-0AB0 2DI 24 VDC
5 6ES7131-4BB01-0AB0 2DI 24 VDC
6 6ES7138-4CA01-0AA0 PM-E 24 VDC
7 6ES7132-4BB01-0AB0 2DO 24 VDC
8 6ES7132-4BB01-0AB0 2DO 24 VDC
9 6ES7132-4BB01-0AB0 2DO 24 VDC
10 6ES7132-4BB01-0AB0 2DO 24 VDC
1. Set the following parameters:
2. Save the configuration.
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
DP). Create OB 1, OB 82 and OB 122 for the project.
table.
button.
Order number
– In the DP slave properties dialog box for ET 200S:
Startup for set- <> actual configuration: enable
– In the DP slave properties dialog box for the PM-E 24 VDC, Module/DP ID 1 (in the
configuration table)
Diagnostics: Missing load voltage
– In the DP slave properties dialog box for the 2 DO 24 VDC, Module/DP ID 7 (in the
configuration table)
Diagnostics: wire break A0
Brief instructions on commissioning ET 200S
2.1 Commissioning on PROFIBUS DP
I address Q address
0
0
Comment
Power module
bytes 0.0 and 0.1
bytes 0.2 and 0.3
bytes 0.4 and 0.5
bytes 0.6 and 0.7
Power module
bytes 0.0 and 0.1
bytes 0.2 and 0.3
bytes 0.4 and 0.5
bytes 0.6 and 0.7
2-5