Enable Startup For Set <> Actual Configuration - Siemens Simatic ET 200S Operating Instructions Manual

Interface modules
10.3 Parameter description for the interface modules
10.3.3 Enable startup for set <> actual configuration
When this parameter is enabled, and
• modules are removed and plugged during operation, then a station failure of ET 200S will
• The actual configuration differs from the expected configuration, the ET 200S remains
When this parameter is disabled, and
• modules are removed and inserted during operation, this leads to a station failure of the
• The actual configuration differs from the expected configuration, there is no data transfer
10.3.4 Option handling, general
Using this parameter you can enable or disable the option handling for the entire ET 200S.
10.3.5 Option handling: Slot 2 to 63
Using this parameter you can enable or disable the checking of the configuration.
• Slots 2 to 63 are enabled: Instead of the configured electronic module you can also insert
• Slots 2 to 63 are disabled: Only the configured module can be located on the relevant
10.3.6 Diagnostic interrupt
This parameter allows you to enable or disable diagnostic interrupts. Diagnostic interrupts
are supported
• On PROFIBUS DP, when the ET 200S is in DPV1 mode.
• On PROFINET IO.
10.3.7 Process interrupt
This parameter allows you to enable or disable process interrupts. Process interrupts are
supported
• On PROFIBUS DP, when the ET 200S is in DPV1 mode.
• On PROFINET IO.
10-6
not occur.
engaged in data transfer with the DP master.
ET 200S.
between the DP master and the ET 200S.
Exception: option handling with RESERVE modules.
a RESERVE module in the relevant slot without diagnostics being reported.
slot. RESERVE modules are treated as incorrect modules. Depending on the setting of
the "Operation at Preset <> Actual Configuration" parameter, the ET 200S will either fail
or remain in data exchange.
Operating Instructions, 12/2005, A5E00515771-03
ET 200S