Table 2-2 Configuration Table In Hw Config For Profinet Io; Configuring Et 200S In The Simatic Manager - Siemens Simatic ET 200S Operating Instructions Manual

Distributed i/o system
Hide thumbs Also See for Simatic ET 200S:
Table of Contents

Advertisement

Brief instructions on commissioning ET 200S
2.2 Commissioning on PROFINET IO
2.2.3

Configuring ET 200S in the SIMATIC manager

Procedure
1. Start SIMATIC Manager and create a new project with an IO controller (e g., CPU 317-2
2. Open the "Properties - Ethernet Interface" window in the HW Config and create a subnet
3. Take the IM151-3 PN from the ET 200S catalog of the hardware catalog and insert it on
4. Drag the individual ET 200S modules from the hardware catalog to the configuration
Table 2-2
Configuration table in HW Config for PROFINET IO
Module
0
6ES7151-3AA10-0AB0 IM151-3 PN
1
6ES7 138-4CA01-0AA0 PM-E 24 VDC
2
6ES7 131-4BB01-0AB0 2DI 24 VDC
3
6ES7 131-4BB01-0AB0 2DI 24 VDC
4
6ES7 131-4BB01-0AB0 2DI 24 VDC
5
6ES7 131-4BB01-0AB0 2DI 24 VDC
6
6ES7 138-4CA01-0AA0 PM-E 24 VDC
7
6ES7 132-4BB01-0AB0 2DO 24 VDC
8
6ES7 132-4BB01-0AB0 2DO 24 VDC
9
6ES7 132-4BB01-0AB0 2DO 24 VDC
10
6ES7 132-4BB01-0AB0 2DO 24 VDC
1. Set the following parameters:
2. Compile and save the configuration.
2-14
PN/DP). For this project, create the OB 1, the OB 82, the OB 83 and the OB 122.
e. g. Ethernet(1).
Ethernet(1):PROFINET IO System (100).
table.
Order number:
– In the IO device properties dialog box for the PM-E 24 VDC,
module 1 (in the configuration table)
Diagnostics: Missing load voltage
– In the IO device properties dialog box for the 2 DO 24 VDC,
Module 7 (in the configuration table)
Diagnostics: Wire break A0
I address
Q address
0
1
2
3
0
1
2
3
Operating Instructions, 12/2005, A5E00515771-03
Comment
Power module
Byte 0.0 and 0.1
Byte 1.0 and 1.1
Byte 2.0 and 2.1
Byte 3.0 and 3.1
Power module
Byte 0.0 and 0.1
Byte 1.0 and 1.1
Byte 2.0 and 2.1
Byte 3.0 and 3.1
ET 200S

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents