Table 8-18 2Pulse Error Types - Siemens Simatic ET 200S Operating Instructions Manual

Alarm, error and system messages
8.1 Alarm, error and system messages on PROFIBUS DP
2PULSE error types
The table below shows the error types on 2PULSE.
Table 8-18 2PULSE error types
Error class
1 00001: Short circuit
D
9 01001: Fault
D
16 10000: Parameter assignment
D
error
1POS INC/Digital, 1POS SSI/Digital, 1POS INC/Analog, 1POS SSI/Analog error types
The following table shows the error displays on the 1POS INC/Digital, 1POS SSI/Digital,
1POS INC/Analog, and 1POS SSI/Analog.
Table 8-19 1POS INC/Digital, 1POS SSI/Digital, 1POS INC/Analog, 1POS SSI/Analog error types
Error class
1 00001: Short circuit
D
16 10000: Parameter assignment
D
error
17 10001: Load voltage 2L +
D
missing
26 11010: External error
D
8-40
Meaning
Short circuit of the sensor supply or the
actuator.
Internal module error occurred.
Parameters have not been assigned to
the module.
Meaning
Short circuit of the sensor supply.
Parameters have not been assigned to
the module.
Only valid for 1POS INC/Digital und
1POS SSI/Digital: Power supply
voltage not present or too low.
Wire break/short circuit of the sensor
signals.
Wire break in the sensor cable, or
sensor cable is not connected.
Sensor is defective or there are faults.
Sensor type, transmission rate, and
monoflop time do not correspond to the
sensor connected; programmable
sensors do not correspond to the
settings on the module.
Remedy
Check the wiring to the momentary-
contact switches and the actuators.
Correct the process wiring.
Replace the module.
Correct the parameter assignment.
Remedy
Check the wiring to the sensor. Correct
the process wiring.
Correct the parameter assignment.
Correct the process wiring. Check the
supply voltage.
Correct the process wiring.
Correct the parameter assignment.
Replace the sensor.
Operating Instructions, 12/2005, A5E00515771-03
ET 200S