Wiring An Interface Module With Profibus Dp Interface (Optically) - Siemens Simatic ET 200S Operating Instructions Manual

Wiring and assembly
5.4 Wiring the ET 200S
3
2
Figure 5-8
①
②
③
See also
Wiring rules for the ET 200S (Page 5-7)
5.4.7

Wiring an interface module with PROFIBUS DP interface (optically)

Introduction
The supply voltage and the fiber-optic cable are connected at the IM151-1 FO STANDARD
interface module via a simplex connector.
Requirements
• Wire the interface module with the supply voltage switched off.
• Follow the wiring rules.
Required tools
3-mm screwdriver
Required accessories
• Package with simplex connectors and polishing sets (6GK1901-0FB00-0AA0)
• Package with plug adapters (6ES7 195-1BE00-0XA0)
5-16
1
Wiring IM151-1 BASIC, IM151-1 STANDARD, and IM151-1 HIGH FEATURE
Labeling strip
Supply voltage (1L+, 2L+, 1M, 2M)
PROFIBUS DP
Operating Instructions, 12/2005, A5E00515771-03
ET 200S