Commissioning On Profinet Io - Siemens Simatic ET 200S Operating Instructions Manual

Note
All interface modules support the default startup. In other words, configuration using the
GSD file or HW Config is not necessary.
The following conditions then apply:
• Preset parameters are used.
• AKF (general identifier format in compliance with the PROFIBUS standard) in the
• Grouping (packing) of the electronic modules is not possible without parameterization.
• All supply voltages on the power modules must be switched on.
• It is not possible to remove or insert modules during operation.
Reference
You can find information regarding the parameter assignment of electronic modules in the
Device Manual ET 200S
under "Parameter for ...".
6.3

Commissioning on PROFINET IO

6.3
6.3.1 Configuring the ET 200S on the PROFINET IO
Introduction
The interface module IM151-3 requires a unique device name in order to operate at an IO
controller (refer to the following chapter).
This chapter describes how to configure and assign parameters to the ET 200S.
• Configuring the project: The systematic arrangement of the different ET 200S modules
• Assigning parameters: Defining the ET 200S parameters with the configuration software.
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
configuration frame
in the chapters
(setup).
Note
The ET 200S can be operated with
6.3 Commissioning on PROFINET IO
Digital Analog electronic Modules
or
STEP 7
V5.3 Service Pack 3 and higher.
Commissioning
in each case
6-13