Installing The Terminating Module - Siemens SIMATIC ET 200S Manual

Installation
4.5

Installing the terminating module

Features
The ET 200S distributed I/O system is completed by the terminating module on the
right-hand side. If you have not connected a terminating module, the ET 200S is
not ready for operation.
Requirements
• The last terminal module must be installed.

Installing the terminating module

1. Hook the terminating module on the rail to the right of the last terminal module.
2. Tip the terminating module back on the rail.
3. Move the terminating module to the left until you hear it snap into place against
the last terminal module.
Figure 4-6
Removing the terminating module
1. Use a screwdriver to push the locking mechanism on the last terminal module
down until the mechanism stops, and move the terminating module to the right.
2. Tip the terminating module so that it comes off the rail.
4-10
Installing the terminating module
1
3
2
ET 200S Distributed I/O System
EWA-4NEB780602402-09