Installation
4.5
Installing the Terminating Module
Features
The ET 200S distributed I/O system is completed by the terminating module on the
right-hand side. If you have not connected a terminating module, the ET 200S is
not ready for operation.
Requirements
S The last terminal module must be installed.
Installing the Terminating Module
1. Hook the terminating module on the rail to the right of the last terminal module.
2. Tip the terminating module back on the rail.
3. Move the terminating module to the left until you hear it snap into place against
the last terminal module.
Figure 4-6
4-10
Installing the Terminating Module
1
3
2
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07