Requirements For Option Handling - Siemens Simatic ET 200S Operating Instructions Manual

7.3.3

Requirements for option handling

Requirements
The following is required for option handling:
• Interface module IM151-1 STANDARD (from 6ES7151-1AA03-0AB0), IM151-1 FO
• for configuration, the GSD file (see table below)
6ES7151-1AA03-0AB0
6ES7151-1AB02-0AB0
6ES7151-1AA04-0AB0
6ES7151-1BA01-0AB0
Note
You do not require a GSD file for option handling in
following:
• IM 151-1 STANDARD / FO
• IM 151-1 HIGH FEATURE
You can find the options handling description in the STEP 7 Online Help.
• Power module PM E-24 ..48 VDC or PM E- 24..48 VDC/24 ..230 VAC
• RESERVE modules as a substitute for the future electronic modules
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
STANDARD ( 6ES7151-1AB02-0AB0 and higher) or IM 151-1 HIGH FEATURE
(6ES7151-1BA01-0AB0)
– from STEP 7 V5.3 SP 2 and
– the current HW update for the interface and power modules. Link the HW Update in
the HW Config via the "Tools > install HW updates" menu command. You can
download the HW updates on the Internet at Customer Support.
– from STEP 7 V5.3 SP 3
One of these power modules must be included in the configuration at least once.
DPV0 operation
SI02806A.GSx SI02806B.GSx
from 07/2003
(V1.0 and higher)
X
–
X
–
7.3 Option handling on PROFIBUS DP
DPV0/DPV1
operation
SI03806A.GSx
– –
X –
– X
– –
STEP 7
if you are using both of the
Functions
DPV0/DPV1
operation
SI280E0.GSx
from 08/2005
(V2.0 and
higher)
–
–
–
X
7-9