Variations In General Technical Specifications For The Et 200S Fc Frequency Converter - Siemens Simatic ET 200S Operating Instructions Manual

General technical specifications

9.6 Variations in general technical specifications for the ET 200S FC frequency converter

Rated operational voltage
The ET 200S distributed I/O system works with the rated voltage and corresponding
tolerances shown in the following table.
ET 200S modules
Everything except motor starters
Static value: Generation as functional extra-low voltage with safety isolation in accordance with IEC 60364-4-41
1
Dynamic value: Including ripple, e.g., at three-phase bridge rectifier
2
9.6 Variations in general technical specifications for the ET 200S FC
9.6
frequency converter
Variations in general technical specifications
The table below presents the variations in the general technical specifications for the
ET 200S FC frequency converter compared to the ET 200S.
Table 9-2
Standards and approvals
Transport and storage conditions
Climatic environmental conditions
Mechanical ambient conditions
Rated operational voltage
Use in Zone 2
9.7 Use of the ET 200S in hazardous area zone 2
9.7
See product information
9-10
Rated voltage
24 VDC
120 VAC
230 VAC
Variations in general technical specifications for the ET 200S FC frequency converter
Section
Use of subassemblies/modules in a zone 2 hazardous area
Tolerance range
20.4 to 28.8 VDC
1
18.5 to 30.2 VDC
2
93 to 132 VAC (47 to 63 Hz)
187 to 264 VAC(47 to 63 Hz)
Variations
The frequency converter has no approval for
cULus for HAZ.LOC.
•
FM (Factory Mutual Research)
•
Marine
•
Free fall: ≤ 0.35 m
Temperature for horizontal installation:
from 0 to 60 °C
Temperature for horizontal installation:
from 0 to 40 °C
See operating instructions for ET 200S FC
Frequency Converter (6SL3 298-0CA12-0xP0)
The ET 200S FC frequency converter is not
approved for use in hazardous area Zone 2
Operating Instructions, 12/2005, A5E00515771-03
.
ET 200S