Installing The Tm-P And Tm-E Terminal Modules - Siemens Simatic ET 200S Operating Instructions Manual

Removing the interface module
The interface module is wired, and the terminal modules are on the right:
1. Switch off the supply voltage on the interface module.
2. Disconnect the wiring and the bus connector on the interface module.
3. Use a screwdriver to push the locking mechanism on the interface module down until the
4. With the locking mechanism depressed, pivot the interface module so that it comes off
4.3

Installing the TM-P and TM-E terminal modules

4.3
Introduction
• The terminal modules serve to receive the I/O modules and power modules.
• The terminal modules can be prewired (without I/O modules).
• All the terminal modules must be installed to the right of the interface module.
Requirements
• The DIN rail is installed.
Required tools
3-mm screwdriver
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
mechanism stops, and move the interface module to the left.
Note: The locking mechanism is beneath the interface module.
the DIN rail.
4.3 Installing the TM-P and TM-E terminal modules
Assembling
4-5