Configuring Ipv6 Mce - HP MSR2000 Configuration Manual

Configuring IPv6 MCE

Network requirements
As shown in
VPNs and advertise the VPN routes to PE 1 through OSPFv3.
Figure 86 Network diagram
Configuration procedure
Assume that the system name of the MCE device is MCE, the system names of the edge routers of VPN
1 and VPN 2 are VR1 and VR2, and the system name of PE 1 is PE1.
1. Configure VPN instances on the MCE and PE 1:
# On MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for each
VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
[MCE-vpn-instance-vpn1] vpn-target 10:1
[MCE-vpn-instance-vpn1] quit
[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
[MCE-vpn-instance-vpn2] vpn-target 20:1
[MCE-vpn-instance-vpn2] quit
Figure 86, VPN 2 runs RIPng. Configure the MCE device to separate routes from different
358