Table of Contents
Advertisement
4
4.2.1
Mounting on Multi-Pos stand
Use the provided M4 x 8 ISO 14581 countersunk head screws (black) to fasten
the stand to the threaded holes on the rear panel
Using two M5 screws, you can also optionally screw the stand to a supporting
surface from the bottom
Adjust the desired angle of inclination
To fix the stand: Tighten the T25 screw
Route the cable from behind through the two supports of the stand and then
through the lateral openings to the connections
Figure 4: Product mounted on Multi-Pos
stand
Further information:
36
Comply with the permissible tightening torque of 2.6 Nm
Comply with the tightening torque for screw T25
Recommended tightening torque: 5.0 Nm
Maximum permissible tightening torque: 15.0 Nm
"Product dimensions with Multi-Pos stand", Page 211
Mounting | Assembly of the product
Figure 5: Cable routing on Multi-Pos stand
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 12/2018
Advertisement
Table of Contents
