DK14 Installation
QRCU3 - DTMF Receiver/ABR Tone Detector Unit
Built-in Auto Attendant
DK14 Built-in Auto Attendant software is enabled by installing a QKYS1 Key (chip) onto the
QRCU3 PCB.
➤ To install the QKYS1 Key
1. Make sure that the DKSU14 power supply switch is Off.
2. Install the QKYS1 into the QKYS1 connector on the QRCU2 PCB (see
3. The QKYS1 does not require Program 03 assignments.
Programming
Refer to "Auto Attendant (Built-in)" in the Overview section of the Strata DK Programming
Manual.
1-18
Figure
1-13).
Strata DK I&M
6/00