Rddu Programming - Toshiba STRATA DK14 Installation And Maintenance Manual

Universal Slot PCBs
PCB Chapter Layout

RDDU Programming

Program 03: Specify Code 16 for slots that support RDDUs and make sure RRCS is enabled for
DTMF operation. Program 03 can be skipped, and Program 91 can be run instead.
Program *09: Assigns DID line extensions to route to station [PDNs] and IMDU or RMDS
Remote Maintenance (see Program 17 below).
Program 10-1: Enables or disables two-line conference.
Program 15: Assigns DTMF/dial pulse dialing, and additional attributes to each line.
Program *15: Makes tenant assignments.
Program 16: Assigns lines to line groups.
Program *17: Assigns intercept port for DID calls to wrong or vacant numbers.
Program 17: Assigns immediate or wink start to DID lines. Also used to assign Auto camp-on and
no-dial tone return for DID lines. Program 17 also Assigns DID lines to route per DNIS and ANI
options (Program 71 and 72) or DID numbers (Program *09).
Program 30: Disables RRCS for dial pulse operation.
Program 39: Assigns line access buttons to digital and electronic telephones.
Program 40: Assigns station access to lines (incoming and outgoing).
Program 41: Assigns station access to lines (outgoing only).
Program 42-0, 1~8: Assigns behind PBX/Centrex operation to each line.
Programs 45~48: Defines toll restriction for any line.
Programs 50~56: Defines least cost routing assignments.
Programs 71 (1~5): Assigns DNIS or ANI option to DID lines.
Programs *71~*73: Assigns telephone to ring called [DN].
Program 93: Assigns names to lines.
9-38
Strata DK I&M 6/00