Toshiba STRATA DK14 Installation And Maintenance Manual page 574

Peripheral Installation
PC/Data Communications Interface Units
➤ To terminate the call
➤
Press the DKT's
...or
1. Type XXX from either PC keyboard. The PC screen displays, OK.
XXX = PDIU-DI escape sequence (see
2. Type ATH from the PC keyboard used in
PC 1 and PC 2 screens display, NO CARRIER. The data call LEDs on each DKT are Off.
RS-232
RS-232
Figure 12-34 DK PC to PC Test Call Using AT Commands
PC-to-Printer Test using Manual Dialing
Note
1. Set the RPCI or DIU programming.
o
o
o
o
2. Make sure the PC is configured to print data from its serial port (the PC COM port connected
to DKT/PDIU-DI or DKT/RPCI-DI port 001). This is normally accomplished using the DOS
MODE commands.
12-66
'DWD 5HOHDVH
Portable PC 1
DKT/RPCI-DI or
DKT/PDIU-DI (200 )
Portable PC 2
DKT/RPCI-DI or
DKT/PDIU-DI (201 )
See Figure 12-35 for additional information.
Program 20: Port 001. LEDs 01, 02, 05, and 17 On; all other LEDs Off.
Program 20: Port 003. LEDs 01, 04, and 17 On; all other LEDs Off.
'DWD &DOO
Program 39: Port 001.
provided.
Default settings for PDIU-DI, S-Registers.
button.
"PDIU-DS to Modem Installation"
Step 3.
MDF
MDF
'DWD 5HOHDVH
(456) and
on Page 12-62).
Strata DK
Digital
(Port 000)
Digital
(Port 001)
1536
(454) buttons should be
Strata DK I&M 6/00