Smdr Printer/Call Accounting Device Installation - Toshiba STRATA DK14 Installation And Maintenance Manual

Program 60
o Item 1: Selects Caller ID, ANI and DNIS or Account Code to be sent out the SMDR Port.
o Item 2: Selects the minimum duration (1.0 or 10 seconds) of calls that will be registered by
SMDR. Any call that lasts less than the set time will not be recorded.
o Item 3: Selects the records of outgoing calls or outgoing and incoming calls to be printed.
o Item 4: Selects the digit length of Account Codes (4 to 15 digits).
Item 5: Allows only long distance call records to be printed.
o
Item 6: DISA security code.
o
Item 7: Credit card calling digit length.
o
Program 76
o If WSIU (DK14), TSIU (DK40i), or RSIU/RSIS (DK424) is used to interface to the SMDR
device use Program 76 to make the appropriate WSIU, TSIU, RSIU/RSIS SMDR
programming assignments.

SMDR Printer/Call Accounting Device Installation

1. Connect the interface cable and the PPTC or PPTC9 adapter from the WSIU (DK14), TSIU
(DK40i), PIOU, PIOUS, RSIU/RSIS (DK424 or DK424i), or SMDR port to the SMDR printer
or call accounting device DB25 or DB9 connector. (See
RSIU, or RSIS TTY and SMDR Wiring in
details.)
2. Set the PIOU or PIOUS SW1 switch to the appropriate bps rate WSIU (DK14), TSIU (DK40i)
– 1200~9600 bps), (PIOU/PIOUS – 300 or 1200 bps, RSIU/RSIS (DK424 or DK424i) as
determined by the baud rate of the printer or call accounting device (Program 76 set WSIU/
TSIU, RSIU/RSIS bps rate).
3. Set the printer or call accounting device to no parity/8-bits/one stop bit.
4. Use Program 60 to set the system for the required SMDR printer/call accounting device
options (See the following section and the Strata DK Programming Manual).
Only the PIOU/PIOUS with the lowest code in Program 03 (41, 42, or 43) or RSIU/RSIS
Note
with Program 76-1 code X2 will provide the SMDR output.
Strata DK I&M 6/00
SMDR Printer/Call Accounting Device Options
Figure 12-21
Chapter 10 – Universal Slot PCB Wiring
Peripheral Installation
and PIOU, PIOUS,
for more
12-39