Bvpu Programming - Toshiba STRATA DK14 Installation And Maintenance Manual

4. After installing the BVPU, gently pull it outward. If the connectors are properly mated, a slight
resistance is felt.
BVPU
Figure 9-1 BVPU Monitor Jack

BVPU Programming

For programming purposes, the Strata DK regards the BVPU card as an REMU and
Note
identifies it as such. Programming instructions for the gateway component are included in
the Voice Over IP Installation Guide.
o Program 03: Specify Code 13 for slots that support REMUs (BVPUs) and make sure RRCS is
enabled for DTMF operation.
o Program 04: Specifies [PDNs]. These are also the numbers that must be received by incoming
Tie lines to route calls to the proper telephones (see Program 17, LED 05).
o Program 10-1: Enables/disables two-line conference.
Program 15: Assigns tandem connections and dial pulse option to Tie lines.
o
Program 17: Assigns immediate or wink start to BVPU Tie lines.
o
Also used to turn on Tie line dial tone return.
Important!
Note When a BVPU is installed in a system, it automatically assumes the next four consecutive
CO line and station port numbers.
o Program 30: Disables RRCS for dial pulse operation.
Program 71 (1~5) and Program 72: Tie/DID DNIS assignments.
o
Program *71~*73: DH/Tie/DID to [DN] ringing assignments.
o
o Program 93: Assigns a name to a Tie line
Strata DK I&M 6/00
Monitor jack
Dealer-supplied
6-wire telephone
modular cord
(cross-pinned)
RD 1
TD 2
DSR 3
DTR 4
DCD 5
SG 6
Call-monitor jack (RJ12)
pin numbering
5243
Universal Slot PCBs
PC with maintenance
console software
PC DB9 or
DB25 Com port
Toshiba PPTC9 or
PPTC25F
PCB Chapter Layout
9-5