Cordless Telephone Installation (Dkt2004-Ct And Dkt2104-Ct) - Toshiba STRATA DK14 Installation And Maintenance Manual

Station Apparatus
Cordless Digital Telephones

Cordless Telephone Installation (DKT2004-CT and DKT2104-CT)

Important!
➤ To install the cordless telephone
1. Select a location for your cordless digital telephone. Avoid excessive heat or humidity. For
wall mounting, refer to the following section.
2. Place the cordless digital telephone's base unit on a desk or tabletop near a standard 120VAC
outlet and within reach of the digital telephone line connection to your Strata DK system.
3. Keep the base unit and handset away from sources of electrical noise (motors, fluorescent
lighting, etc.).
Important!
➤ To mount on a wall
1. Select a wall location near a 120VAC outlet and within
reach of the Strata DK digital line connection.
2. Place the wall plate (shown at right) against the wall, and
with a pencil, mark the position of the screws.With a
punch tool, punch "starter" holes in the wall.
3. Align the wall plate and screws on the wall where the
"starter" holes are and tighten down the screws.
4. Ensure that the wall-mount plate is placed on the wall so
that the "feet" are at the bottom when you are looking at
the inside of the plate.
5. Snap the Base Unit onto the plate.
11-34
Your telephone system must be programmed for Auto Preference for your TALK
button to work. If there is a shared digital telephone, you receive internal system
dial tone automatically after picking up the handset of your deskset. For example, in
a DK system, Program 32 must have a setting other than "00." It is best to set Auto
Line Preference to access Intercom dial tone.
Place the cordless telephone to the right of the DKT. If placed on the left of the DKT,
the cordless antenna will pick up a tone due to its close proximity to the DKT
speaker and electronic parts.
4449
4507
Strata DK I&M 6/00