Tcou Programming; Tbuu And Tbus - Toshiba STRATA DK14 Installation And Maintenance Manual

TCOU Programming

Program 03: Code 11 is specified automatically when TCOU is installed.
Program 10-1: Enables or disables line-to-line Conference and Direct Inward System Access
(DISA).
Program 15: Assigns DTMF/Dial Pulse dialing, DISA, and additional attributes to each line.
Automatic Release (AR) assignments only need to be made for loop start lines; AR is
automatically enabled for ground start CO lines.
Program *15: Makes tenant assignments.
Program 16: Assigns lines to line groups.
Program 39: Assigns line access buttons to digital and electronic telephones.
Program 40: Assigns station access to lines (incoming and outgoing).
Program 41: Assigns station access to lines (outgoing only).
Programs 45~48: Defines Toll Restriction for any line.
Programs 50~56: Defines Least Cost Routing assignments.
Program 78: Assigns special ringing of lines: includes Night Ring Over Page, DISA, Remote
Maintenance via the Internal Maintenance Modem (IMDU), and Integrated Auto Attendant.
Programs 81~89
o Assigns lines to ring selected stations and DH groups.
o Assigns Delayed Ringing to any line.
Programs *81, *84, *87: Assigns which [DN] will flash when the CO line rings a telephone.
Program 93: Assigns names to lines.

TBUU and TBUS

See the ISDN section in this manual for installation of ISDN BRI PCBs.
Strata DK I&M 6/00
DK40i Installation
Printed Circuit Board (PCB) Installation
3-31