Carbon Headset/Handset Straps; Beep Strap - Toshiba STRATA DK14 Installation And Maintenance Manual

Station Apparatus
Electronic Telephone Upgrades
For the V.4 HHEU1 or the HHEU2: if only the headset is connected to the HHEU, cut the
speaker OCA strap.
Note
6. Position the HHEU subassembly on the standoffs inside the base, and secure with the two
screws provided.
7. Connect the HHEU subassembly wire plug to the P1 connector on the electronic telephone
PCB.
8. Cut the HHEU strap on the telephone PCB.
Note
9. Reinstall the telephone base, and secure it with its four captive screws.
Adjust (HESB) Loud Ringing Bell Volume
1. Call the telephone connected to the HESB.
2. Adjust the volume control on both the back of the HESB and the ring volume control on the
telephone.

Carbon Headset/Handset Straps

If a carbon-type handset or headset is connected to the handset jack on the side of the 6500-series
electronic telephone, two straps inside the telephone must be cut.
➤ To cut the straps
Note
See Figures 11-7
1. Loosen the four captive screws on the telephone base and remove the base.
2. Locate the carbon straps, W201 and W202 and cut them.
3. Reinstall the telephone base, and secure it with its four captive screws.

Beep Strap

A "beep" sounds whenever a dial pad button or feature button is pressed on an electronic
telephone.
➤ To eliminate the beep
See Figures 11-7
1. Remove the four captive screws on the telephone base to the telephone and remove the base.
2. Locate and cut the beep strap on the telephone PCB.
3. Reinstall the electronic telephone base and secure in place using the four captive screws.
11-26
Do not cut the speaker OCA strap if connecting an HESB to the HHEU for the loud
ringing bell–even if a headset is also installed on the HHEU.
The HHEU strap must be replaced if the HHEU PCB is removed from the telephone.
It is not necessary to cut these straps if the headset is connected to the HHEU.
and 11-20 and follow these steps:
and 11-20 and follow these steps:
Strata DK I&M 6/00