Toshiba STRATA DK14 Installation And Maintenance Manual page 250

DK424i Configuration
Worksheet 6: DK424i Cabinet Slot Configuration
RPTU must be placed in designated slots as shown in
to 16 or 23 ISDN PRI lines. The RPTU slot provides 16 PRI lines, an additional seven lines
requires that the cabinet slot adjacent to RPTU be vacant.
Table 6-20
1. RPTU PCBs do not have to be installed in the order shown in this table. Example: If only one
2. The slot occupied by RPTU supports 1-16 channels; the slot adjacent to RPTU must be vacant
6. Cordless Telephone Station PCBs
See
o
o The RWIU must be placed in designated slots as shown in
provide up to 16 or 32 Strata AirLink Handsets, depending on where it is placed. The RWIU
slot provides eight handsets. Each additional set of eight handsets requires that an additional
cabinet slot adjacent to RWIU be vacant.
o RSTU or RDSU: Each RSTU or RDSU PCB connected to BSIA requires one slot. These
PCBs cannot occupy a slot that is left vacant to provide capacity for RDTU, RPTU, or RWIU,
as shown in
AirLink Handsets; each RDSU/RSTS provides circuits for four Strata AirLink Handsets.
6-30
RPTU PCB Cabinet Slot Configuration
Slots
PRI Lines
Needed Needed
1~16 1
17~23 2
24~39 3
40~46 4
47~62 5
63~69 6
1~16 1
17~23 2
24~39 3
40~46 4
47~62 5
63~69 6
RPTU is needed, it can be installed in any RPTU slot shown in the table so long as the slot is
supported by the installed processor.
if channels 17 through 23 are needed.
Worksheet 2: Strata AirLink Wireless Telephone
Tables 6-19~6-21. Each RSTU PCB provides circuits for up to eight Strata
Table
RPTU PCBs
RPTU cabinet slot placement
1
Needed
Base Cabinet
1
2
3
Second through fifth cabinets
1
2
3
6-20. The RPTU PCB can provide up
S103-RPTU
2
S104-vacant
S105-RPTU
2
S106-vacant
S107-RPTU
2
S108-vacant
S_01-RPTU
2
S_02-vacant
S_03-RPTU
2
S_04-vacant
S_05-RPTU
2
S_06-vacant
to determine RWIU PCB requirements.
Table 6-21. The RWIU PCB can
Strata DK I&M
1
6/00