Toshiba STRATA DK14 Installation And Maintenance Manual page 178

DK424 Installation
Cabinet Floor Mounting
Bolt Cabinets to a Computer Room Floor
1. Mount the DK424 Base Cabinet on Floor Mount Fixtures (RFMF). See
2. Position the Base Cabinet at the selected installation location.
3. Mark the floor where holes will be drilled. Move the Base Cabinet prior to drilling.
Note
4. Drill holes through tile for 3/8-inch threaded rods.
5. After the tiles have been drilled, insert threaded rods through the holes in the tile and mark the
concrete floor directly beneath the holes in the tiles.
6. Remove the tiles. Use a hammer drill to make holes for 3/8-inch bolt anchors.
7. Install the bolt anchors with plugs in the drilled holes.
8. Using the driving tool and a hammer, drive each bolt anchor into the floor.
9. Screw threaded rods into each bolt anchor.
10. Install a hex nut, lock washer, and flat washer on each threaded rod. Screw the nuts down far
enough to allow floor tiles to be replaced over the threaded rods.
11. Replace tiles over threaded rods in their original positions on the floor.
12. Reach under the tiles, and screw the hex nuts upward until the flat washers are touching the
bottom of the tile.
13. Use a hack saw to cut the threaded rods at a height of approximately 1.5 inches above the floor
tile.
14. Move the Base Cabinet into position over the threaded rods.
15. Secure the Base Cabinet to the floor using flat washers, lock washer, and hex nuts on each
threaded rod.
5-26
Base
Cabinet
BFIF
(Floor
mount
fixture)
Figure 5-17 Floor Mount Installation – Wooden Floor
Cover the Base Cabinet with a drop cloth to protect the power equipment from dust
created during drilling.
Bolt
Lockwasher
Wooden
Floor
1468
Figures 5-13 and 5-18.
Strata DK I&M 6/00