Station Apparatus
Conventional Attendant Console
Conventional Attendant Console
A Strata DK system configured with RCTUB2 or RCTUBA/BB can support two Attendant
Consoles, and systems with RCTUC1/D2 or RCTUC3/D3 can support four Attendant Consoles.
The RCTUA1, RCTUA3, RCTUB1, or RCTUC/D1 do not support Attendant Consoles.
PC and conventional Attendant Consoles require RCTUB2 or RCTUC/D2 R 2 processors or
RCTUBA/BB, RCTUC3/D3, RCTUE3/F3 R3 processors.
The conventional attendant console can be configured with a Toshiba-supplied base (ATT BASE-
1) and an Electroluminescent (EL) or EGA Color CRT.
Installation
Refer to
➤ To install the conventional attendant console
1. Plug in the EL or CRT display to the base with a nine-pin cable, which is supplied with the
display.
2. Plug in the EL or CRT display to a commercial three-prong AC 117V outlet.
3. Use two-pair wiring to connect the MDF to an RJ11 jack at the attendant console location.
4. Plug in the handset to the base RJ45-jack (see
5. Plug in the headset (if needed) to the base.
Conventional Attendant Console Programming
Follow the same programming instructions provided for the PC attendant console. See
Attendant Console Programming" on Page
do not apply to the conventional console.
11-58
"Hardware Installation" on Page 11-41
and the following steps.
Figure
11-28).
11-43. Software Installation and Windows instructions
"PC
Strata DK I&M
6/00