Rdsu Installation; Rdsu Programming - Toshiba STRATA DK14 Installation And Maintenance Manual

RDSU Installation

1. Ensure the SSTU subunit and optional subassemblies are securely attached to the RDSU
(Figure 9-21).
WARNING! The protective shield on the back of the RDSU is designed to protect the
installer from potentially hazardous ring voltage. Do not remove this shield.
2. Insert the RDSU into the appropriate slot, and apply firm, even pressure to ensure proper
mating of connectors. (See
To prevent system malfunction, DO NOT install the RDSU in slot 18 of the
CAUTION!
DK40i system. See Chapter 2 – DK40i Configuration.
3. After installing the RDSU gently pull the RDSU outward. If the connectors are properly
mated, a light resistance is felt.

RDSU Programming

➤
Enter Code 27 in Program 03 for a non-optioned RDSU, or enter Code 28 for an RDSU that
support off-hook call announce and data interface units. To program the RDSU standard
telephone ports (including the RSTS), see
the RDSU digital telephone ports, see
➤
If there are no RDSU options, skip Program 03 can be skipped, and run Program 91 instead.
Strata DK I&M 6/00
Figure 10-23 on Page 10-25.)
"RDSU Programming"
"PDKU2 Programming"
Universal Slot PCBs
PCB Chapter Layout
on Page 9-41. To program
on Page 9-10.
9-41