Toshiba STRATA DK14 Installation And Maintenance Manual page 553

o Program 10-1: If the system is first set for voice, program the VM device to dial the suffix "1"
after station numbers.
o Program 10-2: If LED 04 On for set/cancel operation and LED 06 On for the VM to detect 80
millisecond tones. Also set DTMF Tone return or No DTMF return options (LED 11 and 20).
o Program 10-3: Sets SMDI options.
o Program 13: If the VM device is the message center, set the lowest standard telephone port in
the Program 31 VM group as the message center.
o Program 31: Turn LEDs 04, and 15~20 On, and LED 05, 06, 07 or 08 On for the QSTU2,
KSTU2, RSTU2, RDSU/RSTS, or PESU ports that are connected to the Toshiba VP and
Stratagy VM ports. Turn LED 09 On for VM Auto Attendant "Supervised Transfer" operation;
turn LED 09 Off for VM Auto Attendant "blind transfer" operation and/or VM two CO-line
tandem connection with release 3.2. Do not set these options for telephone station ports.
A, D, and B Tones should be enabled only for VM devices that respond to these tones.
Note
o Program *32: Sets lowest standard telephone port if the Program 31 VM group as message
center for stations using VM.
o Program 33: Sets the QSTU2, KSTU2, RSTU2, RDSU/RSTS, and PESU ports that are
connected to the VM ports to a hunting sequence, starting with the lowest port hunting to the
next highest port, etc. The last hunt should be to an attendant station. Only use Program 33 if
you ar not using Program *40 to set up a VMDA group.
o Program *34: Turns Off LED 01 to disable camp-on BOV tone to a VM port.
o Program 35: LEDs 01 and 02 must be On for stations to receive the message waiting
indication (flashing LED) from a VM device. This program also turns On LED 03 for standard
telephone ports that must support standard telephone message waiting lamps. It is advisable to
turn Busy Station Transfer (LED 20) On for all VM/Auto Attendant ports, and to turn Busy
Station Ringing (LED 19) On for all stations that must never be detected as busy when called
by the VM/Auto Attendant port. Also turn LED 03 Off to disable standard telephone MW
signal to VM ports.
Program 36: Sets Fixed Call Forward to VM [DN] per customer requirements.
o
Program 37: Sets the transfer recall timer for the VM ports to 11~999 seconds minimum to
o
allow Call Forward-No Answer to work on VM transferred calls. Station users can
individually set CF-NA ring time from 8~60 seconds.
o Program 39: Sets the VM-related buttons on the digital and electronic telephones that will be
used to communicate with the VM device.
o Program *40: Sets VM standard ports into a Distributed Hunt Group (same ports set as
Program 31 VM group).
o Program 71 (1-3): Sets Tie/DID/DNIS extensions to ring VM Auto Attendant Ports if Program
*09 is not used.
Program 71-4: Sets the DNIS VM ID code (for Inband Integration only, not SMDI).
o
o Program 76: Sets RSIU RSIS or TSIU SMDI port.
o Programs 81~89: Verifies that the ringing assignments to the VM devices are set per customer
requirements.
o Programs 16, 40, 41, 45~48 and 50~56: Verifies that outgoing CO line access is allowed on
VM ports to allow the VM beeper notification feature to operate.
Strata DK I&M 6/00
Peripheral Installation
Voice Mail Options
12-45