Toshiba STRATA DK14 Installation And Maintenance Manual page 297

13. Use a hack saw to cut the threaded rods at a height of approximately 1.5 inches above the floor
tile.
14. Move the Base Cabinet into position over the threaded rods.
15. Secure the Base Cabinet to the floor using flat washers, lock washer, and hex nuts on each
threaded rod.Mount Cabinets to Computer Room Floor (Unbolted)
16. Make sure that cabinet power supplies (BPSU672A) are installed per
on Page 7-6.
17. Remove front, side, and top covers from all cabinets
Note As shown in
front cover (the bottom left screw must be completely removed) should only be loosened
and the covers slid to the right for removal.
18. Remove plastic locating parts from all cabinet back covers using a Phillips screwdriver
(Figure 7-4).
19. Install a floor fixture (BFIF) on each side of the bottom cabinet
making sure that the fixture is inside of the cabinet edge.
20. Secure a wall bracket (RWBF) to both floor fixtures with the screws provided. Secure the wall
brackets to the wall with customer-provided wood screws and wall anchors.
21. Place a cabinet on top of the bottom cabinet and connect the cabinets together at points "A"
and "B"17 with the screws provided.
22. Install wall brackets (RWBF) on the top of cabinet three and secure them to the wall with
customer-provided wood screws and wall anchors.
23. Add remaining cabinets, making sure that the cabinets are connected together at points A and
B with screws provided.
24. For systems with four or more cabinets, make sure that wall brackets (RWBF) are installed on
both sides of the top cabinet, in addition to cabinet three.
25. Connect the data cable of each Expansion Cabinet to the applicable data cable connector on
the Base Cabinet
should be connected to the connector labeled "CAB. 2", the cable from the second Expansion
Cabinet to the "CAB. 3" connector, etc.)
26. Install ground wiring, AC and reserve power cabling, and PCB cabling per the
"Recommended Installation Sequence"
27. Fill out cabinet/slot identification labels on each cabinet (see
on the cabinets. (The top cover should be installed on the top cabinet.)
Strata DK I&M 6/00
Figure 7-5, the two screws on each side cover and the three screws on the
(Figures 7-9 and 7-12). The data cable from the first Expansion Cabinet
on Page
Step 5: Install Reserve Power
"Install Power Supply"
(Figure 7-5).
(Figures 7-17
7-6.
Figure 7-8), then reinstall covers
DK424i Installation
and 7-21),
7-35