Ratu - Attendant Console Interface Unit; Ratu Installation - Toshiba STRATA DK14 Installation And Maintenance Manual

Universal Slot PCBs
PCB Chapter Layout
RATU – Attendant Console Interface Unit
System:
Circuits per PCB:
Interfaces with:
Older Version(s):
RATU controls and indicators are illustrated in

RATU Installation

1. Insert the RATU (component side facing right) into the slot following the last station PCB.
Apply firm, even pressure to ensure proper mating of connectors (consoles will assume the
next four station port numbers). (See Worksheets in DK424 or DK424i Configuration
Chapters 4
2. After installing the RATU, gently pull the PCB outward. If the connectors are properly mated,
a slight resistance is felt.
Table 9-9 RATU Controls, Indicators, and Connectors
Control/Indicator/Connector
Console 1 indicator CD3
Console 2 indicator CD4
Console 3 indicator CD5
Console 4 indicator CD6
Figure 9-12 RATU PCB
9-26
DK424, DK424i
four attendant console circuits
up to four conventional and/or PC attendant consoles
none
or 6 for RATU slot assignment recommendations.
Type of Component
Red LED
4 3 2 1
CD3
CD4
CD5
CD6
Figure 9-12 and described in
Description
Lights when a PC or conventional console is
not operating. The LED will turn off when the
console is operational. The LED temporarily
flashes when the console is first installed and
the DK424 RCTU processor or DK424i BCU
and attendant console or RATI initialize.
Backplane Connector
Female
Amphenol
Connector
Table 9-9.
Strata DK I&M 6/00