Ferrite Core
Install the Ferrite core provided with the RPRI cable kit as shown in
needed to comply with FCC requirements.
RPTU
Side View
ISDN PRI Jack
2754
Figure 16-5
Ferrite Core Installation
RBSU/RBSS and TBSU Interface Units
System:
DK424 or DK424i and DK40i, Release 4.1 and above
Circuits per PCB:
2 circuits (2B + D each circuit)
Interfaces with:
ISDN BRI S/T when connected to the Public Network or a BRI S-type, TE-1, or TA devices
when connecting to ISDN station equipment
Older Version(s):
none
The Strata DK424 or DK424i and DK40i Release 4.1 system supports the RBSU/RBSS interface
unit according to the common control units resident in the system shown in
only supports the TBSU.
RBSU/RBSS switches, jumpers, and connectors are shown in
16-17
and described in
TBSU switches, jumpers, and connectors are shown in
in
Table 16-12 on Page
Strata DK I&M
6/00
Tie Wrap
Table
16-10.
16-21.
RBSU/RBSS and TBSU Interface Units
Figure
16-5. This core is
CAT5 Shielded Cable
Ferrite Core
FER-CORE-ISDN
Note: The Ferrite core must be
as close as possible to the RPTU.
One Turn
Table
Figures 16-8
and
Figure 16-33 on Page 16-43
ISDN Interfaces
16-1. The DK40i
16-9
on
Page
and described
16-13