Toshiba STRATA DK14 Installation And Maintenance Manual page 329

T1
Slot Assignments
Program 10-1: Use to enable or disable Two-Line Conference and Direct Inward System Access
(DISA).
Program 15: Use to assign DTMF/Dial Pulse dialing, DISA, and additional attributes to each line.
Automatic Release (AR) assignments only need to be made for loop start lines; AR is not needed
for ground start lines. Also use to enable DID lines with DNIS and ANI options.
Program *15: Use to make tenant assignments.
Program 16: Use to assign lines to line groups.
Program 17: Use to assign Tie/DID Auto Camp-on, and second dial tone.
Program *17: Use to assign intercept port for DID line calls to wrong or vacant numbers.
Program 30: If RDTU Tie and/or DID lines are Dial Pulse (DP—Program 15-1), then Program 30,
LED 11 should be On for the Tie/DID station port numbers; if they are DTMF, LED 11 should be
Off.
Program 39: Use to assign line access buttons to digital and electronic telephones.
Program 40: Use to assign station access to lines (incoming and outgoing).
Program 41: Use to assign station access to lines (outgoing only).
Program *41 Series: Run to assign RDTU channel line operation, and coding and framing modes.
Program 42-0, 1~8: Use to assign behind PBX/Centrex operation to each line.
Program *42 Series: Use to assign timing reference for RDTUs.
Programs 45~48: Use to define Toll Restriction for any line.
Programs *50, *51, *52: Use to define Caller ID/ANI assignments.
Programs 50~56: Use to define Least Cost Routing assignments.
Program 59: Use to assign T1 lines to attendant console buttons.
Program 71~74: These programs are used in place of Program *09 to assign DID/Tie/DNIS line
ringing destinations.
Program 71 (1~5): Tie/DID DNIS assignment (optional used in place of *09. Also see Program
04).
Program *71~*73: Tie/DID telephone/[DN] ring assignments.
Program 78: Use to assign special ringing of lines: includes Night Ring Over Page, DISA, Remote
Maintenance via the Internal Maintenance Modem (IMDU), and Built-in Auto Attendant.
Programs 81~89: Use to assign loop and ground start RDTU CO lines to ring selected stations on
incoming calls.
Programs *81, *84, *87: Assigns [DN] LEDs to flash when CO line rings a telephone.
8-7
Strata DK I&M 6/00