Rpci-Di/Pdiu-Di/Pdiu-Ds Data Communication Installation Tests - Toshiba STRATA DK14 Installation And Maintenance Manual

RPCI-DI/PDIU-DI/PDIU-DS Data Communication Installation Tests

The following material provides tests for five RCPI/DIU data call applications:
o PC-to-PC
o PC-to-Printer
o Internal PC-to-External PC
o External PC-to-Internal PC
o PC Auto Dial Voice Call
These test routines only check the data communications mode of the RPCI-DI; they do not check
the RPCI-DI API mode. The telephone and port numbers used in these figures are provided as an
example. When performing the test, use the appropriate port and telephone numbers for the
system.
Each of these tests can be conducted with manual dialing from a digital telephone's dial pad or AT
dialing from a personal computer's keyboard; however, only the preferred method of dialing for
application is presented.
PC-to-PC Test with AT Commands
See Figure 12-34, "DK PC to PC Test Call Using AT Commands"
Note
information.
1. Set RPCI or DIU programming.
o Program 20: Ports 000 and 01. LEDs 01, 02, 05, and 17 On; all other LEDs Off.
Program 39: Ports 000 and 01.
o
should be provided.
o Default settings for PDIU-DI S-Registers.
2. Make sure PC 1 and PC 2 are on-line with communications software and that the parameters
of each PC and its communication software are set to the same values (data transmission rate,
parity, data bits, stop bits, flow control, etc.).
If using an RPCI-DI, you may need to switch the RPCI from the TAPI mode to the Data
Note
Communications Mode before proceeding with Step 3. To place the RPCI into the data
communications mode from the PC keyboard: Set Num Lock to On and type 240 while
holding the Alt key down (this is HEX F0). If in the data communication mode, ATC0
will switch the RPCI-DI back to the TAPI mode.
3. From PC 1's keyboard, type ATDD201 and press Enter (AT commands must be capital
letters).
o The data call LEDs light on DKT 200 and 201.
o PC 1 displays: CONNECT XXXX.
o PC 2 displays: RING.
PDIU-DIs or RPCI-DIs are now in the communication mode.
Typing from the PC 1 keyboard appears on the PC 2 monitor and vice versa.
Note
Strata DK I&M 6/00
'DWD &DOO 'DWD 5HOHDVH
(456) and
Peripheral Installation
PC/Data Communications Interface Units
for additional
(454) buttons
12-65