Cordless Telephone Connectors; Handset Battery Pack Installation; Removing And Charging Your Battery Pack - Toshiba STRATA DK14 Installation And Maintenance Manual

Station Apparatus
Cordless Digital Telephones

Cordless Telephone Connectors

2. Plug the AC adapter into a standard 120VAC
wall outlet.
3. Route the power cord where it is not a trip
hazard, and where it will not become chafed and
create a fire or electrical hazard.
4. Wrap the power cord around the notch on the
bottom of the base unit (see
5. Check to see that the power LED is on,
indicating the telephone has power.
6. Before using your cordless digital telephone, be
sure to raise the antenna to the vertical position.
Attach/Remove Belt Clip to Handset (optional)
➤ To attach the belt clip to the handset
1. Snap the tabs of the belt clip into the notches on the sides of the handset.
2. Use the belt clip to attach the handset to your belt or pocket for convenient portability.
➤ To remove the belt clip
1. Pry one tab at a time from the notch on the side of the handset.
2. Carefully lift the belt clip off.
The belt clip is designed to fit snugly onto the handset.

Handset Battery Pack Installation

1. Place a charged battery pack onto the handset so that it slides easily along the ridges.
If your battery is not charged, see
11-36.
2. Slide the battery pack up onto the handset until it clicks into place.
You are now ready to configure your cordless digital telephone.

Removing and Charging Your Battery Pack

Before using your new cordless digital telephone, the battery must be charged continuously for 6
to 8 hours.
➤ To remove the handset's battery pack
1. Press in on the battery pack release latch.
2. Slide the battery pack off the handset.
Note
11-36
Figure
You may have to pull hard to slide the battery pack off, when the handset is new.
11-26).
Figure 11-26 Line Out Cord
"Removing and Charging Your Battery Pack" on Page
1175
Strata DK I&M 6/00